How to Replace a Nissan Juke Spare Key
Nissan Juke is an attractive and fun hatchback that has unique engine design. It's a bit noisy however it's still a fun car to drive.
The battery that powers the key fob on your Nissan Juke should be replaced every two years or more, or if the battery is low. It's easy to do at home, but you'll require some tools.
Dead Coin Battery
If the key fob in your Nissan Juke is not working, you should check the battery for coins. It could be dead and need to be replaced. This is a quick fix that only takes a few moments. You can do this by flipping the fob and removing the tiny latch/release at the back. Remove the old battery and then insert an alternative one, making sure that it is facing down in the fob. Line between the two halves of the fob carefully.
The fob will need to cleaned if it has been exposed to water prior to being able to install a new battery. You can clean the fob with isopropyl electronic cleaner and a paper towel. Then, let it dry completely before installing the battery.
To start the car, the key fob must also be connected to the car. This can be accomplished by following the instructions in the owner's manual or by using an OBDII scan. If the key fob is not been paired, that is the most likely cause of why it stopped functioning. A malfunctioning chip inside the fob can also cause it to stop working however, this is a rare. In this case it is possible that a new receiver could be required. If this is the case, it will need to be replaced by an accredited technician.
Water Damage
The key fobs run on batteries, and the batteries should be replaced every two years or as soon as your vehicle stops responding when you hit the "start" switch. The rubber seals on keys keep water out, but submerging your key fob in the ocean or in pool water can damage the electronic chip. If this is the case then you'll need a replacement key from Nissan or a locksmith.
It's possible that the computer has lost connection to the key fob This could result from a variety of factors. This can be fixed by restarting the car. If the "Key ID error" message persists then you should contact Nissan for assistance.
Three typical causes are a dead key fob battery or a key that's not programmed, or damaged key fob that is damaged. The first two are easy to fix, and the latter is a bit more difficult to identify and repair on the spot, but it can be fixed with a bit of patience. WhoCanFixMyCar allows you to compare Nissan Key Replacement prices in your local area and then book your repair. nissan key replacement near me reviews about local Nissan dealerships, Nissan mechanics, and garages in only a few seconds.
Faulty Chip
The key fob of your Nissan Juke contains a special chip that sends a message to the vehicle whenever you turn it. If the chip is not functioning properly it could cause the key to stop working. If this is the case the issue will only be resolved by replacing the key. Your Nissan Juke key may be defective due to a variety of reasons, such as water damage or an inactive coin-battery.
Check the chip for any water damage If your key fob has stopped working after a bath or wash. Make sure the clips that hold the chip are tight. Also, make sure the chip isn't surrounded by water. If you spot any signs of water damage on the electronic component, take off the battery and wipe it down with isopropyl ethanol or electronic cleaner.
If the chip is damaged, you'll need to contact your local locksmith or dealer. They will need to know the year model, make, and year of your vehicle to locate the replacement. You will also have to record your VIN (Vehicle ID Number) so the dealer or locksmith knows what key you have. This will allow them to look up the correct key code and make sure that they are cutting the right one.
Faulty Receiver Module
The key fob sends out a radio signal to your vehicle that performs various functions. It can unlock your trunk while you rush to the car with your groceries or start your car by pressing the button on the fob. It can also open your windows and turn the horn on in the event that you lock the keys inside your car.
If the key fob does not work, it may be due a problem in the receiver module. The receiver modules are tuned so they can detect specific frequencies which correspond to the signals sent by Nissan key fobs. A damaged receiver module can prevent your car from responding to the signal sent by the key fob from Nissan.
It's always best to have a spare Nissan key fob in case the original key you have or breaks. A locksmith or a dealership can program an additional key to work with your Nissan. This will save you from the hassles of losing your keys or locking them inside your car.
If your Nissan Juke's key fob was exposed to rain or clean tap water, you can fix the issue by cleaning it with isopropyl, or an electronic cleaner. If the chip has become damaged, you will need to purchase a new keyfob which can be coded for your vehicle by a locksmith or dealer.